Months of Maintenance-Free Filtration!
Klir Di-4 Filter Drop-In Fleece Filter System fits in most sumps with a 4" filter sock tray and will eliminate the need to replace filter socks. The 50-micron fleece roll will help eliminate free-floating particles and automatically advance when the fleece starts to clog, exposing new fleece. The Di-4 has the capability of handling up to 2800 LPH and producing crystal clear water.
Maximum Flow Rate - 2800 LPH
- Fits in tight areas
- Compatible with most 4" filter sock holes
- Includes 25 yards of 50-micron fleece
- Fully automatic with smart controller
- Removable lid with carbon insert for noise and odor control
- Multiple units can be placed side-by-side
Traditionally filter socks have been used to polish aquarium water from particulates and detritus, and now with the Klir Di-4 Drop-In Fleece Filter System, you can throw away your filter socks for good! The Klir Di-4 can hold up to 25 yards of 50-micron fleece allowing it to last for months at a time without having to be maintained in any way. The compact design lets it fit in tight spaces, and since you only need to access it once every few weeks or months, having direct access like filter socks in no longer a concern. Some tanks may need to replace the fleece once every couple months where others may need to replace it more often, and that will depend on your bio-load along with feeding habits and a few other variables, but in most cases, a single fleece roll can last up to 3 months without having to be replaced.
How the DI-4 Works
Water will be able to enter the Klir Di-4 from two sides and then travel down to the bottom where it can be pushed through the fleece material, where any particles will be collected. Over time the debris collected will start to clog the fleece tower and the water level will start to rise in the sock tray, and that is where the optical eye sensor comes into play. Once the water level reaches the eye, the Klir will automatically activate the roller, exposing new fleece and allowing water to flow freely again, dropping the water level below the sensor.
Dimensions - 4.125" L x 4.125" W x 17.125" H | 10.5cm L x 10.5cm W x 43.5cm
Flow Rate - 2800 LPH max
Filter Sock Hole Requirements - 3.8" (min O.D.) to 4.25" (Max O.D.) |
Power Consumption - 0.6A @ 12VDC
1x Klir Di-4 Filter Tower Assembly
25 Yards 50-Micron Fleece Roll
1x Motor Assembly
1x Controller Assembly
1x Optical Eye Sensor
1x Controller Power Supply
1x Activated Carbon Insert
1x 3.85" Filter Sock Adapter Plate
1x 4" Filter Sock Adapter Plate (preinstalled)
1x 4.25" Filter Sock Adapter Plate
- Sump with filter sock tray
- Capable of holding 1.5" (3.5cm) of water above the sock tray
- 8.125" (~20cm) of space below the sock tray
- 4.125" (~10.5cm) opening above the sock tray